Custom Gcode For robo R1

[ncapaldi1985]

Hi, I want to have me robo r1 do its autolevel procedure before heating. I looked in the script but don't see anything in there for heating, Is there a way to add this in?

[BaudR8]

edit your starting gcode script, after the G28 put your bed leveling code and then at the very end of the statrting gcode put:

(if you have a heated bed):
M140 S[bed0_temperature]
M190 S[bed0_temperature]
M104 S[extruder0_temperature]
M109 S[extruder0_temperature]

(if you dont have a heated bed):
M104 S[extruder0_temperature]
M109 S[extruder0_temperature]

[Menissalt]

Would this throw off the measurements since heat will expand the extruder and bed?