Page 1 of 1
S3D 3.0 Head did not retract
Posted: Fri Jun 26, 2015 10:17 am
by bone
The printer head on my TAZ4 did not retract after the print was finished. It was automatically done this on the other versions of the S3D software.
Re: S3D 3.0 Head did not retract
Posted: Sat Jun 27, 2015 9:40 am
by JoeJ
I just looked at the gcode generated form v3.0. It still retracts at the end, same as before.
Re: S3D 3.0 Head did not retract
Posted: Sat Jun 27, 2015 12:20 pm
by dsegel
Check your GCode Ending Script and make sure the head retract is still in there.
Re: S3D 3.0 Head did not retract
Posted: Sat Jun 27, 2015 10:20 pm
by bone
I left a large print go over the weekend at work. I'll see how it comes out.
The also homed the X axis after the print was done and it didnt do on that print.