Hello All,
Why cant I make this printer print with simplify? IS it that the bed is to close to the extruder? All I get is alot of clicking and the extruder moving across the glass really fast but not laying anything down. Any help would be greatly appreciated. Thank you.
-
blessedone82
- Posts: 4
- Joined: Sun Jun 28, 2015 3:34 pm
Re: Printing with Davinci 1.0
That sounds like the nozzle is too close to the bed. Have you tried increasing the gcode z-axis offset? Increase that by 0.5mm and then try again (G-Code tab of FFF settings)
-
blessedone82
- Posts: 4
- Joined: Sun Jun 28, 2015 3:34 pm
Re: Printing with Davinci 1.0
Thank you Joe. I did a manual calibration of bed using the ole paper trick and it seems to have helped.
