Simplify3D User Forum

I happened to be in the room when my 20 hour print got to doing some bridging on a PLA part I sliced using Ver 1.5
and I thought I would share what this awesome software can do. I have never touched the bridging settings.

Pretty impressive, haven't had prints push the M2/ Creator that far, yet.....

I'm firmly convinced the M2 and Creator are the finest setup in Fused Filament Fabrication (FFF) in it's class, and beyond. If you can't do it with a M2 and Creator, hang it up and buy an Eggbot.




Printed on Makergear M2
Scaled to 35%
Sliced to .1mm using Creator
Material: PLA by Repraper.com

hey earsmith-

would you mind sharing an fff file of the settings you used to make that print?