Simplify3D User Forum

I wanted to inform you guys I've been able to crash the software in the latest update 3.0 by setting the following values:

Top solid layers: 0
Bottom solid layers: 0
Outline/perimeter shells: 0

When I set that in a process and press prepare to print, it crashes. It's probably incorrect configuration, but still a bug.

Ryno wrote:I wanted to inform you guys I've been able to crash the software in the latest update 3.0 by setting the following values:

Top solid layers: 0
Bottom solid layers: 0
Outline/perimeter shells: 0

When I set that in a process and press prepare to print, it crashes. It's probably incorrect configuration, but still a bug.

I think there's only issue when slicing with zero perimeter shells.

Not really a bug..insofar as there's no error in the software that's causing the crash.

But there is a deficiency in the validation behind the entry of numeric values on the settings page.....where validation should be preventing non-sensible values such as zero outlines, etc.