[DONE] Differing layer prints
Posted: Sun Jul 12, 2015 11:53 am
by Joules
Hi, I have a question. Would it be possible at some point to print both 0.1mm and 0.2mm models on the same bed. Perhaps different colour models to represent the differing layer prints. I just thought printing every second layer for the 0.2mm objects or something along those lines.
Many Thanks for the V3.0 of Simplify3D.
Joules
Re: Differing layer prints
Posted: Mon Jul 13, 2015 6:02 am
by BaudR8
This has always been available, make two processes, one using .1mm layer height and another using .2mm layer height. Then select the models you want for each process. Hit prepare to print and you will be prompted to select a process, choose to use both and in "continuous mode",
Re: Differing layer prints
Posted: Mon Jul 13, 2015 6:15 am
by JoeJ
Re: Differing layer prints
Posted: Mon Jul 13, 2015 4:36 pm
by Joules
Many thanks, after I posted my question I NOTICED it was possible..... I am grateful for the tutorials though.