bed Z
Posted: Wed Jul 15, 2015 1:21 pm
hello
I would like the bed rises 1mm when I start a project and how to configure ?
thank you
I would like the bed rises 1mm when I start a project and how to configure ?
thank you
I'd recommend you using the software's G-Code offsets. For raising the 1 mm bed closer to the extruder, you will want a value of -1 mm in the Z-Axis input box.efes wrote:hello
I would like the bed rises 1mm when I start a project and how to configure ?
thank you
for more information, I suggest starting here. viewtopic.php?f=8&t=2210