Page 1 of 1
Keychain texte
Posted: Sat Jul 25, 2015 1:20 pm
by efes
hello
I draw this :
results were not very good?
or I have to refine my settings?
Thank you
240° extrudor
110° bed
thx help
Re: Keychain texte
Posted: Sat Jul 25, 2015 1:54 pm
by efes
Re: Keychain texte
Posted: Sat Jul 25, 2015 2:30 pm
by jimc
yes holes like that are from running too hot and or your infill is not printing clean. turn down your temp 5 deg. for your infill, you can either increase your infill extrusion width to around 140% or change to an infill pattern that prints on every layer. bring you outline overlap down as well. no need to have that so high. 10-20% is fine. the higher the infill extrusion width the higher you need that overlap setting.
Re: Keychain texte
Posted: Sun Jul 26, 2015 5:37 am
by efes
jimc , big thank-you !
Result very clean now ...
my wife is very happy
there are ways to do better?
