Page 1 of 1
Communication problems since updating to 3
Posted: Sun Jul 26, 2015 8:39 pm
by Mbisjr23
Anyone else having trouble since updating s3d? Since I've updated, my machine has been acting weird. Won't jog axis' randomly, Got crc error, randomly takes a while to begin print, even extruder is acting differently. I have Mac version and robo3d. Anyone else having these issues?
Re: Communication problems since updating to 3
Posted: Sun Jul 26, 2015 8:54 pm
by jimc
nothing on my mac version. that has worked flawlessly. my pc version the print will freeze for 5-6 sec about 5 min into the print. does it every time. i really try not to print from usb anyway.
Re: Communication problems since updating to 3
Posted: Thu Aug 13, 2015 8:56 pm
by Narg
I'm seeing a few comm issues, but fortunately not during printing (though other issues are there...) USB comm seems to drop a lot with S3D 3.0, and even causes the printer to freeze at times. When I can get S3D to work, I'm stuck printing to file and putting on a SD card. This is on a FF printer.
Re: Communication problems since updating to 3
Posted: Fri Aug 14, 2015 5:56 am
by AndersE
I also have some problems, probably the comm also,
When starting a print, it homes, then goes down (delta), then it pauses for 1-20 sec (randomly) before starting the print.
Have never done that before.
Re: Communication problems since updating to 3
Posted: Fri Aug 14, 2015 7:59 am
by Mbisjr23
My biggest problems have been with the extruded. It is severely under extruding and acting weird. I haven't been able to print since the upgrade came out. Thought I just had a clog but deep cleaned hot end and still same. Always something
Re: Communication problems since updating to 3
Posted: Sun Aug 16, 2015 12:20 pm
by Narg
Mbisjr23 wrote:My biggest problems have been with the extruded. It is severely under extruding and acting weird. I haven't been able to print since the upgrade came out. Thought I just had a clog but deep cleaned hot end and still same. Always something
I too see this problem, so much that I can't use S3D 3.x right now. I just e-mailed support, and will try to post here if they can fix it. The printer works fine, and I can print with my FlashForge slicer. But S3D 3 is very buggy right now.
Re: Communication problems since updating to 3
Posted: Thu Aug 20, 2015 12:37 am
by Mbisjr23
Narg wrote:Mbisjr23 wrote:My biggest problems have been with the extruded. It is severely under extruding and acting weird. I haven't been able to print since the upgrade came out. Thought I just had a clog but deep cleaned hot end and still same. Always something
I too see this problem, so much that I can't use S3D 3.x right now. I just e-mailed support, and will try to post here if they can fix it. The printer works fine, and I can print with my FlashForge slicer. But S3D 3 is very buggy right now.
please keep me posted. i am on vacation right now but when i get back i need to tackle this.