Bed Leveling Wizard not working (v3.0.1, Leapfrog Creatr)

[mfc]

Still not working right with Leapfrog Creatr after update to 3.01

Z moves are a violent shuddering motion, and table doesn't return to zero Z height.

Anyone have a solution?

[JoeJ]

It works fine on my leapfrog creatr. Just ran the bed leveling wizard again to be sure. It worked perfectly.

I wonder if you have a bad firmware version on yours??

[mfc]

Joej - thanks for the report.

I was wondering about the the firmware. I'll look into it. Can you check the version you have installed?

Matt

[mfc]

Update: Fixed it by "reset all settings" and just starting over.

Must have been some random bug introduced somehow.