Simplify3D User Forum

So I’ve noticed that whenever I have a round hole on the top surface one of my prints that around the edges there is always small holes. I understand its because of the angle but I'm nt sure if theres a way to try reduce it or eliminate it.

I’m wondering if anyone can help with settings to try and eliminate them. I’m using PLA, 3 outer shells and slicing with Simplify3d.

Thanks

a picture would help

Here is a pick

try increasing the "outline overlap" setting on the "Infill" tab. try increasing by 10%

Thank you that seemed to do it. The default was at 15% and i brought it up to 30%.