Bridging issue
Posted: Thu Aug 06, 2015 3:37 pm
http://www.thingiverse.com/thing:910216
When printing the above model, there are two areas which are bridged. The S3D slicer appears to do something strange during the bridge which results in filament being dropped underneath.
Examining the above image, where my blue arrow is pointing, you can see that the bridge has two strands down each outside and then the middle is filled. The middle filling drops through the bridge.
How do I fix this?
Thanks
Phil
When printing the above model, there are two areas which are bridged. The S3D slicer appears to do something strange during the bridge which results in filament being dropped underneath.
Examining the above image, where my blue arrow is pointing, you can see that the bridge has two strands down each outside and then the middle is filled. The middle filling drops through the bridge.
How do I fix this?
Thanks
Phil
