Simplify3D User Forum

Posted: **Sun Aug 09, 2015 10:15 am**

Anyone have this happening? I have included some pictures. Using MatterControl, this doesn't happen. Only with Simplify3d so far. The islands in the print are significantly thicker for some reason. It is not reflected in the tool path data.
Extruder steps have been tuned, etc.

Any suggestions?

ABS material.
Rostock V2 Printer
0.6mm E3D Volcano extruder.

https://www.dropbox.com/home/Solidworks ... 234540.jpg

https://www.dropbox.com/home/Solidworks ... 234547.jpg

Posted: **Sun Aug 09, 2015 2:46 pm**

Think I found the reason. Will upload video. The perimeters are switching from inside-out, to outside-in.... not sure why. I have selected Inside-out as my options.

Simplify3D User Forum

Thicker islands than rest of part?

Thicker islands than rest of part?

Re: Thicker islands than rest of part?