Simplify3D User Forum

Simplifying the 3D Experience!
https://forum.simplify3d.com/

Simplify3D problem or CTC printer problem???

https://forum.simplify3d.com/viewtopic.php?t=3393

Page 1 of 1

Simplify3D problem or CTC printer problem???

Posted: Fri Aug 28, 2015 9:21 pm
by Fernando1
Hello guys..!!

I'm new using simplify. I don't if this is problem is created by software or hardware http://www.imgur.com/gallery/St9i1
Thx for you help

Re: Simplify3D problem or CTC printer problem???

Posted: Mon Aug 31, 2015 7:35 am
by JoeJ
Layer shifting is almost always a mechanical issue. Usually a loose belt or a set screw that isn't holding.
All times are UTC-04:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited