Simplify3D User Forum

I would like to modify my end-gode block to do the following:
If Z >= 75 AND Z < 150, then move build plate incrementally down by 5 mm
Else If Z < 75 then move Z to absolute position of 75
Else Move Z to absolute position 155

Can I even do If-then statements in G-code? I have a Makerbot Replicator 2.

scott216 wrote:I would like to modify my end-gode block to do the following:
If Z >= 75 AND Z < 150, then move build plate incrementally down by 5 mm
Else If Z < 75 then move Z to absolute position of 75
Else Move Z to absolute position 155

Can I even do If-then statements in G-code? I have a Makerbot Replicator 2.

I don't know of a way to do an IF statement, but the safe way to do this, would be to have

G1 Z155 F1800 ;

At the ending script, then it would move to the bottom after every print.

It already moves to the bottom, but I don't want it too.