Simplify3D User Forum

Posted: **Mon Sep 07, 2015 11:15 am**

Hi,
it it possible to adjust Extruder width just for Shell/Outline(or Outline-Outline overlap) for each extruder ?
because some time Outline-Outline print doesn't stick together
but no problem with Outline-infill since S3D can set overlap between them.

Posted: **Tue Sep 08, 2015 1:20 pm**

If there are gaps between your outline shells, than you are under-extruding. Increase the extrusion multiplier on your Extruder tab.

Simplify3D User Forum

Perimeter Shell Extruder width?

Perimeter Shell Extruder width?

Re: Perimeter Shell Extruder width?