Simplify3D User Forum

Hi
I am just trying to use Simplify3D (coming from using the Cube Software) and I am having trouble with some of my parts
When I print them on the cube they work fine, but when I load them in Simplify and view the print preview it shows some areas of the outer wall missing, when I guess it thinks it was to thin?? But it doesn't do that in the Cube Software
So my question - is there anyway to tell the settings to preserve the outer wall? So that the outside perimeter prints 100% with no missing bits?

The picture below is the part, its a face and has eye holes, but not open on the side like it is


Any advise would be appreciated

Regards
Julie

It looks like the walls are too thin. You can't print features that are smaller than your nozzle size. I would try thickening the 3D model in those places.

Alternatively, you can trick the software to print smaller features by setting a manual extrusion width that is a bit smaller than your nozzle size (i.e. set to 0.35mm for a 0.4mm nozzle).

Thanks Joe
I tried changing the nozzle and that didn't help, so I have been reworking the parts
Its just annoying that the software would see a thin part and say, its too thin so I'm not going to print it
Rather than saying its thin, so it will get the minimum nozzle thickness available - which obviously the cube software does

If you feel strongly about this, then why not have your say here: viewtopic.php?f=23&t=3471

If the development team see how strong feelings are, then they may do something about it!