Simplify3D User Forum

Hi Guys, so far everything I've thrown at the software has come out great. I ran into one issue though that I can't seem to nail down. See http://www.thingiverse.com/download:229729 and when I slice it in the software, the supports already in the model appear to only be in the first 5-10 layers, and go missing there after?

RiC0MD,

Check out the replies in http://forum.simplify3d.com/viewtopic.php?f=9&t=207.

Dale

Thanks Dale, didn't see that thread. I had a feeling though that was going to be the case.

Thanks again!