Simplify3D User Forum

Posted: **Thu Sep 17, 2015 12:23 pm**

We have water soluble PVA that we use for supports but removing large supports can get pretty messy.
An option to create just the joints of the support out of PVA and the middle out of the print material would make removing supports a lot easier.
This way the supports will remain ridged in the water while the PVA connecting them to the model will dissolve and free the supports.

Posted: **Fri Sep 18, 2015 11:31 pm**

+1
Allowing us to choose the extruder for dense support layers would be great. Bonus points if we could specify extruder for bottom support layers.

Posted: **Sat Sep 19, 2015 12:45 pm**

+1
This has been suggested in at least one other thread and would be a great (and unique I believe) addition to S3D!

Posted: **Mon Sep 21, 2015 11:54 am**

+1

I would be intersted in this too.

Posted: **Tue Sep 29, 2015 3:58 pm**

+1 on this

Simplify3D User Forum

Dual extrusion option for joints of support structures

Dual extrusion option for joints of support structures

Re: Dual extrusion option for joints of support structures

Re: Dual extrusion option for joints of support structures

Re: Dual extrusion option for joints of support structures

Re: Dual extrusion option for joints of support structures