When I do sequential printing using a raft, it prints all of the rafts first and then comes back and prints the parts on top of the rafts.
I would like it to print each part, from the raft up, sequentially.
-
bray.christopher
- Posts: 62
- Joined: Fri Jun 19, 2015 11:24 pm
Re: Sequential Printing Rafts
I would like this as well. S3D is not the best when it comes to sequential printing which is sad because I have been needing to do a lot of it lately.
Re: Sequential Printing Rafts
What would be the benefit of this feature? You can't pull parts off the bed until the job is done anyway, and if you're talking about building one part on the bed and then dropping down to start another you're introducing a big collision risk between printer parts and the just completed model.
