Page 1 of 1
Makerbot Rep 2 with Sailfish
Posted: Sat Oct 10, 2015 11:46 am
by dennisn8tkk
Do you have your program set up for a Makerbot Rep 2 WITH sailfish firmware installed ? I know you should already have it set up for printers that have the Makerbot firmware. Thinking of updating the firmware TO Sailfish anyone have any thoughts on this as well ?
Re: Makerbot Rep 2 with Sailfish
Posted: Sat Oct 10, 2015 3:46 pm
by 66tbird
I've done the Sailfish upgrade (years ago) and never looked back. S3D has the option and works no problem
Re: Makerbot Rep 2 with Sailfish
Posted: Sat Oct 10, 2015 8:11 pm
by AK_Eric
S3D is pretty firmware agnostic: It spits out .gcode (and in the instance of Makerbots & their clones, converts this to .x3g) for consumption by the firmware: I have a custom built bot running Marlin, a Rep1 and Rep2x both with Sailfish, but use S3D to slice & output for all of them.