Page 1 of 1
Slowdowns=blobs
Posted: Mon Oct 12, 2015 1:50 pm
by AndersE
I have model of a hand where the printspeed drastically reduces speed at some points in the perimeters, thus making bulges that
is visible on the outside.
What is this? Bad model with too many small moves?
Re: Slowdowns=blobs
Posted: Mon Oct 12, 2015 3:45 pm
by Frguy
look this topic, perhaps is it the same problem
viewtopic.php?f=9&t=3630
Re: Slowdowns=blobs
Posted: Tue Oct 13, 2015 6:00 am
by JoeJ
The cooling settings can slow down your printing speed. I would expect that would occur for small layers like maybe the last few fingers of your hand model. You can set the minimum cooling speed slowdown to limit how slow the print will go due to cooling.