Having a hard time figuring out dual extrusion wizard
Posted: Thu Oct 22, 2015 7:55 pm
by Grifftech
I have a key chain that has raised lettering on it and am trying to figure out how to print the letters in a different color. I went a head and split it into two stls, one with the bottom of the keychain and the other is the lettering. But when I import them into S3D through the wizard how do I get them to line back up so the letters are on top of the bottom?
Re: Having a hard time figuring out dual extrusion wizard
Posted: Fri Oct 23, 2015 1:32 am
by PinballGeorgio
Isn't it easier to use the pause function on your printer and change the filament at the right Z height?
That's the way I print this.
Re: Having a hard time figuring out dual extrusion wizard
Posted: Fri Oct 23, 2015 5:13 am
by CompoundCarl
If you haven't watched some of their tutorial videos, they have quite a few that explain exactly what you're talking about
https://www.youtube.com/watch?v=qPufaJhyqME
https://www.youtube.com/watch?v=g1V-5aA03dQ (jump to 1:40)