Simplify3D User Forum

Essentially a Slider that will allow us to choose how much the slicer tries to pack into the same area. I'm constantly getting overfilled/underfilled top and bottom layers, while my infill and layer height are perfect (AKA not over extruding or underextruding).

The slicer is literally just creating huge gaps inbetween the layers. Its frustrating because rep-host and other slicers do not have this problem and print the initial layers fine, but I <3 using simplify 3d. I can provide examples of this behavior if requested.

How about posting a picture? That should make it easier to give suggestions.

In the meantime, just saw this guide which you may want to check out. There's a section on this issue: https://www.simplify3d.com/support/prin ... top-layers