Simplify3D User Forum

My Davinci AIO 1.0's extruder packed it in this morning, heated up at the beggining of the print and then just stopped, I am not sure if anyone has had this happen or not, but if you have any fix ideas I would be glad to hear them..

On that note, if I am to replace the extruder what type should I replace it with ?

thanks in advance

Sischka

It may not be the extruder, it may be the MOSFET driving it.
in answer to you question I like the E3d v6. search youtube for videos on it.

Cool thanks,
I had a look at the E3d v6 looks good and the heat range is much better, Is it an easy install to replace my AIO's hotend with the E3D ?
Steve