Simplify3D User Forum

Now that the Lulzbot TAZ 5 comes with a .5mm nozzle, can we get a profile for that? Tried just changing the nozzle diameter from .35mm to .5 mm and the layer height from .2 to .25, which are specified in the Cura profile for the TAZ 5 with .5mm nozzle. Didn't work too well.

If we can't get a profile, can we get some suggestions?
Thanks,

jomireyn3 wrote:Now that the Lulzbot TAZ 5 comes with a .5mm nozzle, can we get a profile for that? Tried just changing the nozzle diameter from .35mm to .5 mm and the layer height from .2 to .25, which are specified in the Cura profile for the TAZ 5 with .5mm nozzle. Didn't work too well.

If we can't get a profile, can we get some suggestions?
Thanks,

Same here. My work just bought Simplify 3d to go with our new Taz 5 and I went back to Cura because I dont have the time to mess with it.

Where you guys able to get the profile? I changed the default settings a little but can not print without raft.

BioTech wrote:Where you guys able to get the profile? I changed the default settings a little but can not print without raft.

Got no response from Simplify3D at all. I have no idea if they even read these feature requests.

Got no response from Simplify3D at all. I have no idea if they even read these feature requests.

If you simply posted in the Feature Request section of the forum....which is a user forum provided by Simplify3D and not a Simplify3D forum....you would not get any response from them. They do, however, read the forum to get user feedback for error correction and new feature purposes.

If you want an answer from Simplify3D, you'll need to email them on [email protected] or use https://www.simplify3d.com/contact-us/ .

dkightley wrote:

Got no response from Simplify3D at all. I have no idea if they even read these feature requests.

If you simply posted in the Feature Request section of the forum....which is a user forum provided by Simplify3D and not a Simplify3D forum....you would not get any response from them. They do, however, read the forum to get user feedback for error correction and new feature purposes.

If you want an answer from Simplify3D, you'll need to email them on [email protected] or use https://www.simplify3d.com/contact-us/ .

Thanks, good to know. I guess the title "Feature Requests" on the name of the forum is a little misleading, if it's not actually a place to request a feature, but only a place to tell other people your wishes.

if it's not actually a place to request a feature, but only a place to tell other people your wishes.

To clarify.....this IS a place to request a feature be considered for inclusion in a future release. It IS NOT a place to ask the software producers for information or help with an issue. Simplify DO READ this section of the forum....but only when they are looking at what to include in future releases.