Simplify3D User Forum

Hi Everyone,

Im having issues with this one file and was wondering if it has happen to anyone else. So, on this one particular file simplify will not add support in the center part, It includes it on the outer edges, but excludes the center where it's concave. I have opened other parts, into the same built platform and click on generate support and it puts it all over the part as it should. I'm not sure what I'm doing wrong, is there anything obvious that I'm missing?

Thanks All,

You might try making the support pillar resolution smaller if it is a small part. Other then that, its hard to tell without a factory file to look at.