Page 1 of 1
Saving after adding support
Posted: Wed Nov 11, 2015 11:26 am
by mondo50m
I have taken a file and added quite a bit of support to get it to print correctly. How can I save the file so that I can use it again without having to redo the support. Or, is this not possible?
Milt
Re: Saving after adding support
Posted: Wed Nov 11, 2015 11:45 am
by dkightley
Either save the whole thing as a factory file......or if you're likely to be wanting to edit the shape and reload. there's an option to save the supports in the custom support box.
Re: Saving after adding support
Posted: Thu Nov 12, 2015 7:52 am
by JoeJ
File > Save Factory File. This will include the support structures as well as the model placement.
Re: Saving after adding support
Posted: Thu Nov 12, 2015 8:55 am
by mondo50m
Thank you very much gentlemen.
Milt