Page 1 of 1
Outer layer rectilinear fill angles
Posted: Tue Nov 24, 2015 10:28 pm
by billyd
How do I set the outer layer rectilinear fill angles? If I change the infill angles it has no effect on the outer layers.
Re: Outer layer rectilinear fill angles
Posted: Wed Nov 25, 2015 9:20 am
by Fred B
Unfortunately, you can't. I would also like to see a concentric option.
The start angle is already a feature request. I hadn't thought about the end angle...
But, the workaround is to rotate the part (hint, the first angle used for the bottom layer is 45 degrees)
Re: Outer layer rectilinear fill angles
Posted: Thu Nov 26, 2015 12:18 am
by billyd
Fred B wrote:Unfortunately, you can't. I would also like to see a concentric option.
The start angle is already a feature request. I hadn't thought about the end angle...
But, the workaround is to rotate the part (hint, the first angle used for the bottom layer is 45 degrees)
Understood but I have one print that only fits on the build bed at 45 degrees so I am stuck.
Re: Outer layer rectilinear fill angles
Posted: Thu Nov 26, 2015 2:27 am
by horst.w
billyd wrote: ... that only fits on the build bed at 45 degrees so I am stuck.
May be that's raft.
H.