Ecubmaker Pro 2 - configuration
Posted: Thu Nov 26, 2015 1:48 pm
by kpsxtyone
Hi,
i just purchased S3D and have an Ecubmaker Pro2 - anyone care to share their profile?
thank you!
Re: Ecubmaker Pro 2 - configuration
Posted: Fri Nov 27, 2015 7:17 am
by JoeJ
That printer is pretty similar to many others that S3D already supports. I'm sure it's compatible, you just might not find a pre-built profile for it, since that machine isn't all that popular.
If I was you, I would just go to Help > Configuration Assistant, choose Other, and then answer the questions that the wizard asks you. That should give a good starting point. I've used that process for several of my printers.