Simplify3D User Forum

I installed Dream Maker Pro using the setup Config But any file i take to Dream maker give me a message Please uses UltiGcode .

What else do i have to change to get the right Gcode to Dream Maker Pro ?

I've seen this warning on the Ultimaker 2 before. It just pops up on the LCD screen, and I hit "Continue" to proceed through the warnings and then the print starts. Prints great. The Ulticode is just a Cura-specific thing, but it's not needed to print on the machine.

what Gcode setting should I being using ?

They already have the DreamMaker Pro settings in the Configuration Assistant. Just load that profile. It will automatically use the correct firmware, since the profile controls the firmware settings as well (watch this if you want to learn more about that: https://www.youtube.com/watch?v=NYPUAqT4UyI)