Optimize Prints For x

[dguisinger]

It would be nice to have an Optimize Print For function.
With For being
- Speed
- Quality
- Strength

I'm not referring to infill or printer speed, I'm talking about model position and supports.

For example, supports take time to print, but increase quality (in most cases). But there also may be a position that isn't obvious (and requires more support) but could lead to better quality. Or using a particular face may give a part better strength based on the way its sliced and laminates the layers.

Or, maybe the software could notice areas that may be weak because they get narrow and automatically partition those areas and apply a higher quality print setting when selecting Strength.

I realize this requires a lot of flipping the model around and reslicing and running calculations, but would it ever be nice to just take a model and not even have to think about it in terms of the print out.