Page 1 of 1
The roof of the hollow model is not bridged.
Posted: Tue Jan 12, 2016 11:38 pm
by LOONG
When printing the hollow model,the roof is not bridged.
Why？
How to change my FFF setting to solve the problem？
Re: The roof of the hollow model is not bridged.
Posted: Wed Jan 13, 2016 6:30 am
by CompoundCarl
Why is this in the feature request section? And if you want help, you will probably need to post your factory file.
Re: The roof of the hollow model is not bridged.
Posted: Mon Feb 01, 2016 5:41 am
by LOONG
CompoundCarl wrote:Why is this in the feature request section? And if you want help, you will probably need to post your factory file.
All roofs of hollw models are not bridged。Therefore，when I print a solid model with 0% infill and 1mm top solid layers，zhe top of the model are messed。