When I print in ABS with my printer completely wrapped in a plastic bag, my solid print doesn't warp very much but the support loves to lift off the bed. Is there anything I can do? I have a tight first layer with a nice layer of hairspray and I even apply superglue to the edges but for larger support pieces, it will almost always lift.
Heated bed 92C, this is as high as it can really go
Extruder 230C
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Support lifting off heated bed
Slow down the first layer printing speed. Or you could also add a brim with lots of outlines to create a nice flat plastic surface (for example using 20 brim outlines)
