LCD 12864

[erniehatt]

Having a few problems getting Marlin to compile after setting the LCD in configuration h.
what is the correct settings. Thanks

[BaudR8]

All you should have to change in the configuration.h file is one line:

Code: Select all

//#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER

remove the two //'s to uncomment it

If you're having issues compiling the firmware, make sure you followed the note above it as well:

Code: Select all

==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib

You need that library installed in your arduino environment if you havent done so

[erniehatt]

Thanks I did that, but am still getting messages about something not named, may be I installed the library wrong, not sure

[erniehatt]

problem solved, seems I had the wrong version of U8glib.