Anyone using S3D with a Ultimaker 2+?
Since its not a supported printer yet, anyone can give me advice how to use this printer with S3D?
Thank you very much.
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Ultimaker 2+
It's nearly identical to the UM2, so I would just start with that profile which is already included in the configuration assistant. Seriously, there were very few changes that require any modifications to the slicing settings. The new filament drive and improved fan don't require any settings changes, they just improve the machine's function.
