Page 1 of 1
Variable infill
Posted: Fri Jan 22, 2016 2:59 pm
by haimiko
Is there an option/way to print different infill % based on layer height? I need 100%, to maximize strength, infill for the first say 20 layers then down to 30%, to save on material
Re: Variable infill
Posted: Fri Jan 22, 2016 3:07 pm
by jimc
yes you need to set up 2 processes. set the first one to whatever height and infill you want then the second to start where the first one left off and the reduced infill %
Re: Variable infill
Posted: Fri Jan 22, 2016 3:35 pm
by haimiko
Hah. Never occurred to me to use multiple processes in the same print. You're AWESOME! Worked like a charm!
Thankyou