I've scoured the forum and am having a hard time setting up a Simplify 3D FFF profile for my old MakerFarm Prusa i3 8" w Magma hotend.
Could anyone here w the same setup please share their profile settings w me? I tried a Prusa i3 profile and my hotend almost crashed through my glass bed plate.
-
insultcomicdog
- Posts: 1
- Joined: Tue Jan 26, 2016 11:22 pm
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: MakerFarm Prusa i3 8" FFF Profile Settings
I've use the configuration assistant for this before and it was working fine. Just go to Help > Configuration Assistant, select Other at the bottom, and then follow the on-screen prompts.
