-
SHoutzager
- Posts: 131
- Joined: Sun Jan 03, 2016 4:02 pm
Keeping filament loaded
This just a general question and not specific to Simplify. Is it a good idea to unload the pla from the machine when it is sitting around or does it matter? I have not really noticed a difference in keeping it ready to go but was wondering what others have noticed.
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Keeping filament loaded
I don't usually unload it. Just don't leave it sitting at full temperature for hours
