Simplify3D User Forum

Does that firmware support multiple extruder a? What does the temperature response look like as you switch between different extruders?

It looks like they are using a response that is different than every other popular firmware out there that I know of. Seems silly, as that's going to cause issues with many other programs in addition to S3D.

CompoundCarl wrote:Does that firmware support multiple extruder a? What does the temperature response look like as you switch between different extruders?

It looks like they are using a response that is different than every other popular firmware out there that I know of. Seems silly, as that's going to cause issues with many other programs in addition to S3D.

Like I wrote, it is plain simple smoothieware. Shame that S3D doesn't even offer smoothieware as a firmware in the preference panel.

I tried to switch to other pins on the board, or reconfiguring it as another hotend and stuff, it just does not show the temp. Installed in a VM under win7 on my Mac the temperature is shown. So, just a S3D-Mac Bug.