Simplify3D User Forum

I've just tried printing a part slice with S3D on one of our Replicator 2's and it seems as if there is no acceleration control going on with travel moves. The direction transitions are violent, and caused the Y axis to skip it's belt (yes the belt was too loose and has been tightened). Does anyone know if S3D has turned off acceleration settings during the build, or somewhere to set them in the software? I don't see this issue in parts I've sliced for our Ultimakers.

Thanks in advance.

Accel is handled in the firmware. There's no way to "turn it off" from the software.