Getting Macros to stick?

[CharlesRAnderson]

I apologize if this is already posted someplace but I searched and didn't find an answer to my question.

I am using S3D and a Makergear M2 printer. I have discovered the awesome feature of Macros that I can set in the Firmware settings. Only problem is that after every print they get deleted. I looked at the video someone posted showing how the firmware takes it settings from the print settings. But that doesn't help me any.

I gotta believe there is a way to tell it to save these settings for the macros so that I don't have to keep manually updating them after every print. Its quite annoying.

Thanks for your help!

[CompoundCarl]

You have to actually Export your new firmware configuration with the new macros and then edit your profile to use that new config. This video walks through the whole process: https://www.youtube.com/watch?v=NYPUAqT4UyI