Simplify3D User Forum

Hello,

After my print job finishes, I would like to have the printer do a few things, turn off fans, Z axis +10.

So far all I can find are absolute G code commands to move the Z axis, is there a command that I can use to make a relative Z axis move?

Also, is there a command to turn off the cooling fan running on the extruder?

Thank you in advance,
Ken

I suppose I should add to this I believe that M107 RR will turn the fan off, but is there a way in simplify to test this, or how do I add it to the post print procedure?

I am a complete NEWB to 3D printing and am trying to get my stuff together.

Sorry if this has been asked and answered before.

Ken

Add in Tab Script inder Ending script.
I use this:

G91 ;set relative positioning
;G1 E-1 F300 ;retract the filament a bit before lifting the nozzle
G1 Z10 ;lifts the nozzle off of the print
M106 S0 ;extruder fan off
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M84 ; disable motors

Second line is commented out for this moment

Thank you very much!