Ultimaker 2+ printing smaller than it should
Posted: Fri Mar 18, 2016 3:41 pm
Hi guys and gals
My printer is the Ultimaker 2+ and I've noticed that it is printing 1mm smaller than the design is suppose to be.
I've also had to dial down the extrusion rate.
I am pretty certain that the UM2 profile isn't suitable for the UM2+ printer.
Any advice is appreciated
In the mean time I have applied a 1mm horizontal offset to see if that resolves the issue.
My printer is the Ultimaker 2+ and I've noticed that it is printing 1mm smaller than the design is suppose to be.
I've also had to dial down the extrusion rate.
I am pretty certain that the UM2 profile isn't suitable for the UM2+ printer.
Any advice is appreciated
In the mean time I have applied a 1mm horizontal offset to see if that resolves the issue.