-
bulldogguitars
- Posts: 1
- Joined: Sun Mar 27, 2016 2:32 pm
Davinci 2.0 will not connect with software
I was hoping I could get some advise on how to get a Davinci 2.0 to communicate with Simplify 3D. I have went through and verified the com port and baud rate and they are set. The software just doesnt want to talk to it. The Davinci firmware is 2.1.8.2, I hope thats not going to be an issue in the communciation gap. I'm new at this so any help would be greatly appreciated.
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Davinci 2.0 will not connect with software
It works fine with my da vinci 2.0. Are you sure no other programs are connected to it? You can't connect if XYZ is already connected
-
andersengeorg
- Posts: 2
- Joined: Fri Mar 04, 2016 6:13 pm
Re: Davinci 2.0 will not connect with software
Just got S3D short time ago for my Davinci 2.0A.
Had no problem connecting.
Made a small screen dump of how i connected
Can be downloaded here
http://arloese.dk/images/stories/setup.wmv
Had no problem connecting.
Made a small screen dump of how i connected
Can be downloaded here
http://arloese.dk/images/stories/setup.wmv
