Page 1 of 1
MG2 V4 rev D filament guide tube issue?
Posted: Mon Mar 28, 2016 1:59 pm
by Amateur6
Hi everyone --
Is the guide tube supposed to actually insert into the top of the extruder? Because as shown in the Simplify3D final hardware checks, it appears to do so
but maybe that's not the case and it's just resting there?
The hole in my M2 appears large enough for the filament but NOT the tube (see attached). Thanks in advance!
Re: MG2 V4 rev D filament guide tube issue?
Posted: Tue Mar 29, 2016 8:27 am
by CompoundCarl
I think it just sits on top
Re: MG2 V4 rev D filament guide tube issue?
Posted: Tue Mar 29, 2016 11:33 pm
by jimc
It just sits on top. Makergaer has been like this fir years but if you check their github they might have the most current filament drive file posted which does have a hole to support the guide tube
Re: MG2 V4 rev D filament guide tube issue?
Posted: Wed Mar 30, 2016 5:19 am
by dkightley
The Makerbot Rep2 has a hole that is supposed to take the filament guide tube, but on both of my bots, the guide tube jumps out as soon as the print head starts to move around....and I've never had any issues that can be attributed to the end of the tube dancing up and down as filament retracts and feeds!
I've even had it come adrift at the other end and the tube has floated around being held between the top of the print head and the filament spool....and the print was unaffected.
Re: MG2 V4 rev D filament guide tube issue?
Posted: Wed Mar 30, 2016 1:30 pm
by Amateur6
Fantastic, thanks for the replies everyone!
dkightley wrote:...and I've never had any issues that can be attributed to the end of the tube dancing up and down as filament retracts and feeds! I've even had it come adrift at the other end and the tube has floated around being held between the top of the print head and the filament spool....and the print was unaffected.
And thanks for the extra reassurance, dkightley!