Page 1 of 1
Temperature graph has problems above 200
Posted: Fri Mar 22, 2013 2:46 pm
by Q*bert
When temperatures go above 200 degrees, the temperature graph stops tracking the actual temperature. It seems to just keep going up at the same slope it was at before it passed 200.
Scared the heck out of me until I turned on "Verbose" and could see that the actual temperature was OK.
On a side note, I'm getting some pretty good prints out of Creator now.
Re: Temperature graph has problems above 200
Posted: Fri Mar 22, 2013 5:11 pm
by Simplify3D
Interesting.. We will definitely investigate this for the next release. Thanks for the report!
And glad you're starting to see some high quality prints! I just got done printing a gargoyle model with v1.0.5, stock M2 settings, and break-away support structures. The result was pretty amazing
Re: Temperature graph has problems above 200
Posted: Wed Apr 24, 2013 3:23 pm
by Lateralg
I'm running v 1.1.1 and it has 200 C ceiling.
Re: Temperature graph has problems above 200
Posted: Wed Apr 24, 2013 3:32 pm
by mathisyourfriend
Simplify3D wrote:Interesting.. We will definitely investigate this for the next release. Thanks for the report!
And glad you're starting to see some high quality prints! I just got done printing a gargoyle model with v1.0.5, stock M2 settings, and break-away support structures. The result was pretty amazing
photos/video please.
Re: Temperature graph has problems above 200
Posted: Wed Apr 24, 2013 4:06 pm
by Simplify3D
It defaults to 0-200 degrees, but if the temperature goes above that it will scale automatically. If you're printing ABS, I'm sure you know what I mean.
And I'll post some photos as soon as we get our DSLR back in the lab. A camera phone just doesn't do it justice
