Page 1 of 1
bottom layer problem
Posted: Fri Apr 08, 2016 10:53 pm
by ARTISAN
hey now..
first print(test) with two extroders..
t.s layer 3
b.s layer 3
shells 2
what did i miss?
Re: bottom layer problem
Posted: Sat Apr 09, 2016 5:04 am
by dkightley
Your piccie is not too clear.....but could the bottom of the model not be flat.
If so, try lowering the model downwards a tad. That will then cut it off flat when printing.
Re: bottom layer problem
Posted: Sat Apr 09, 2016 7:39 am
by ARTISAN
it is flat...and as can see...thers no ozzing...
just part of one red quarter(red) and full quarter (blacj) bottom layer is missing
Re: bottom layer problem
Posted: Sat Apr 09, 2016 8:23 am
by dkightley
it is flat...and as can see...thers no ozzing...
Sorry, I can't see...your picture is out of focus and not very bright. With little to go on, I'm not able to help.