Simplify3D User Forum

Greetings all,

I've search the forums a bit for this, but no luck so posting.

I print a lot in petg. I've noticed that the infill globs up a bit and in my experience that happens because too little is extruded during infill. My perimeters are perfect. The issue is only with infill, and it's one I've had with other slicers as well.

I was hoping there was a way to be able to set the infill extrusion multiplier as well as the overall extrusion multiplier.

Am I mising something or is this a feature request?

The option is on the Infill tab. It's called the "infill extrusion width". For example, if you set that to 200%, it will extrude twice as much plastic for the infill.

Nice, thanks!

I saw that and didn't put 2 and 2 together to understand that it woud extrude more... TGIF!