Page 1 of 1
How do i get s3d to connect to usb after running sd print?
Posted: Sat Apr 30, 2016 12:05 pm
by noah
Connecting...
[ERROR] Could not connect to COM4 at baudrate 250000:
Serial error: could not open port COM4: [Error 2] The system cannot find the file specified.
Even resetting the printer doesnt seem to help but it eventually will connect for some reason.
Re: How do i get s3d to connect to usb after running sd prin
Posted: Sun May 01, 2016 4:32 am
by CompoundCarl
That looks like a system error. If the OS can't connect to the port, there's nothing the software can do. Perhaps the printer is resetting or disconnecting itself.
What printer do you have?
Re: How do i get s3d to connect to usb after running sd prin
Posted: Sun May 01, 2016 8:41 pm
by noah
robo r1+
Re: How do i get s3d to connect to usb after running sd prin
Posted: Mon May 02, 2016 6:11 am
by andrewk72
Could be an electronics issue or a bad USB port on the control board